哪位高手知道2948-l3设备的配置怎样更改为3550的配置？

inhe

哪位高手知道2948-l3设备的配置怎样更改为3550的配置？下面为部分配置：\r\nip subnet-zero \r\nbridge irb \r\n!\r\ninterface FastEthernet1 \r\nno ip address \r\nno ip directed-broadcast \r\nbridge-group 1 \r\n! \r\ninterface FastEthernet2 \r\nno ip address \r\nno ip directed-broadcast \r\nbridge-group 2 \r\n!\r\n......\r\ninterface FastEthernet47.1 \r\nencapsulation dot1Q 1 native \r\nno ip redirects \r\nno ip directed-broadcast \r\nbridge-group 1 \r\n! \r\ninterface FastEthernet47.2 \r\nencapsulation dot1Q 2 \r\nno ip directed-broadcast \r\nbridge-group 2 \r\n!\r\ninterface BVI1\r\nip address 10.1.3.252 255.255.255.0\r\nno ip redirects\r\nno ip directed-broadcast\r\nstandby priority 110 preempt\r\nstandby ip 10.1.3.254\r\n!\r\ninterface BVI2\r\nip address 10.1.2.252 255.255.255.0\r\nno ip redirects\r\nno ip directed-broadcast\r\nstandby priority 110 preempt\r\nstandby ip 10.1.2.1\r\n!\r\nip classless\r\nip route 0.0.0.0 0.0.0.0 10.1.3.1\r\nbridge 1 protocol ieee\r\nbridge 1 route ip\r\nbridge 2 protocol ieee\r\nbridge 2 route ip\r\n!\r\nend\r\n能不能将2948上面的配置更改后上传上来，我是个菜鸟，不太清楚具体命令，只好照葫芦画瓢了！先谢谢高手了！

cnadl

如果接口不变的话\r\n\r\n假设你有一台干净的35（如没有请自行清空配置）\r\n\r\n首先在35上建立vlan 2\r\n\r\nvlan 2\r\n\r\n把35的对应接口划入vlan\r\n\r\nsw\r\nsw mo ac\r\nsw ac vl [1/2]  <---此处1或2对应2948上该接口的bridge-group\r\n\r\n在35的47口做\r\n\r\nsw\r\nsw tr en do\r\nsw mo tr\r\n\r\n在35全局下配置vlan 接口\r\n\r\nint vl 1\r\n抄bvi 1配置即可，抄不上也没所谓\r\n\r\nint vl 2\r\n同上，抄bvi 2配置\r\n\r\n然后把路由做起来\r\nip route\r\nip route 0.0.0.0 0.0.0.0 10.1.3.1\r\n\r\n这就基本可以了，更多安全等特性设置请自行研究