- 论坛徽章:
- 0
|
p650, 1*2way 1.2G cpu 升到2*2way 1.2G cpu。\r\n\r\n加了一个5120 backplane,一个2way 1.2g cpu。\r\n二个cpu processer card 内存都是4096M。\r\n加了backplane后,在1号cpu 槽插二个cpu中的任何一个都可正常启动,同时插二个cpu led报错:\r\n\r\n9400\r\n94b2 (9400与94b2循环几次,手册说重启SP,升microcode可解决,但照做了没解决)\r\nB00E\r\n4b2e25df\r\nU0.1-p1-c1\r\n\r\n换了一个backplane还是同样问题。\r\n\r\n机器firmware刷到最新。\r\n\r\n1. If the system fails to progress after this checkpoint is put in the display, do the following: \r\na. Activate the service processor pinhole reset switch on the system’s operator panel.\r\nb. If the hang repeats, check with service support to see if there is a firmware update that fixes the problem.\r\nc. If not, or the update does not fix the problem, replace the service processor/PCI backplane, location: U0.1-P2.\r\n\r\n以上是手册建议解决这个问题的方法,但我找不到service processor/PCI backplane, location: U0.1-P2.所对应的物理部件 |
|