在6509中加入WS-SVC-IDSM-2 如何配置

kt133

RT\r\nsh inventory\r\nNAME: \"4\", DESCR: \"WS-SVC-IDSM-2 8 ports Intrusion Detection System Rev. 6.2\"\r\nPID: WS-SVC-IDSM-2     , VID: V04, SN: SAD103707HV\r\n\r\nNAME: \"sub-module of 4\", DESCR: \"WS-SVC-IDSUPG IDS 2 accelerator board Rev. 2.5\"\r\nPID: WS-SVC-IDSUPG     , VID:    , SN: ADBG62600312\r\n\r\n\r\n\r\nsh module\r\n4    8  Intrusion Detection System             WS-SVC-IDSM-2      SAD103707HV\r\n4  0019.2f1c.ad6e to 0019.2f1c.ad75   6.2   7.2(1)       5.1(4)       Ok\r\n4  IDS 2 accelerator board     WS-SVC-IDSUPG      ADBG6260031  2.5    Ok

SwordsMan

session slot X  processor 1 ?

kt133

原帖由 SwordsMan 于 2007-7-11 12:02 发表 \r\nsession slot X  processor 1 ?

\r\n\r\n\r\nThe default escape character is Ctrl-^, then x.\r\nYou can also type \'exit\' at the remote prompt to end the session\r\nTrying 127.0.0.41 ...\r\n% Connection timed out; remote host not responding\r\n

lwc_119

上面是什么意思啊,不懂啊

kt133

恩 原来是IDS 死机了\r\n#hw-module module 4 reset\r\nOK