- 论坛徽章:
- 381
|
ClientAliveCountMax
Sets the number of client alive messages (see below) which may be sent without sshd receiving any messages back from the client. If this threshold is reached
while client alive messages are being sent, sshd will disconnect the client, terminating the session. It is important to note that the use of client alive
messages is very different from TCPKeepAlive (below). The client alive messages are sent through the encrypted channel and therefore will not be spoofable.
The TCP keepalive option enabled by TCPKeepAlive is spoofable. The client alive mechanism is valuable when the client or server depend on knowing when a con-
nection has become inactive.
The default value is 3. If ClientAliveInterval (see below) is set to 15, and ClientAliveCountMax is left at the default, unresponsive ssh clients will be
disconnected after approximately 45 seconds.
ClientAliveInterval
Sets a timeout interval in seconds after which if no data has been received from the client, sshd will send a message through the encrypted channel to request
a response from the client. The default is 0, indicating that these messages will not be sent to the client. This option applies to protocol version 2 only.
楼主看下你服务器上的这两个的值是多少 |
|