- 论坛徽章:
- 0
|
alloc_pdc_pages: Relocating PDC from 0xffff800000 to 0x7fa01000.
gate64: sysvec_vaddr = 0xc0002000 for 2 pages
NOTICE: autofs_link(): File system was registered at index 3.
NOTICE: cachefs_link(): File system was registered at index 5.
NOTICE: nfs3_link(): File system was registered at index 6.
td: claimed Tachyon XL2 Fibre Channel Mass Storage card at 0/8/0/0
td: claimed Tachyon XL2 Fibre Channel Mass Storage card at 0/9/0/0
System Console is on the Built-In Serial Interface
Entering cifs_init...
Initialization finished successfully... slot is 9
Logical volume 64, 0x3 configured as ROOT
Logical volume 64, 0x2 configured as SWAP
Logical volume 64, 0x2 configured as DUMP
Swap device table: (start & size given in 512-byte blocks)
entry 0 - major is 31, minor is 0x12003; start = 0, size = 8388608
Starting the STREAMS daemons-phase 1
Checking root file system.
vxfs fsck: file system had I/O error(s) on meta-data.
intent log marked bad in super-block
cannot perform log replay
file system is not clean, full fsck required
pass0 - checking structural files
pass1 - checking inode sanity and blocks
DIAGNOSTIC SYSTEM WARNING:
The diagnostic logging facility has started receiving excessive
errors from the I/O subsystem. I/O error entries will be lost
until the cause of the excessive I/O logging is corrected.
If the diaglogd daemon is not active, use the Daemon Startup command
in stm to start it.
If the diaglogd daemon is active, use the logtool utility in stm
to determine which I/O subsystem is logging excessive errors.
感觉这个系统有问题,一直起不来,现在光标一直在闪烁,当前不知道是什么情况,求解,谢谢 |
|