ti DM365 跑LINUX 内核驱动问题

812412648

[    1.251981] Creating 7 MTD partitions on "davinci_nand.0":
[    1.257535] 0x000000000000-0x000000300000 : "bootloader"
[    1.269216] 0x000000300000-0x000000500000 : "params"
[    1.280892] 0x000000500000-0x000000900000 : "kernel"
[    1.292399] 0x000000900000-0x000003100000 : "filesystem1"
[    1.304693] 0x000003100000-0x000003900000 : "data1"
[    1.316411] 0x000003900000-0x000006100000 : "filesystem2"
[    1.328437] 0x000006100000-0x000008000000 : "data2"
[    1.339948] davinci_nand davinci_nand.0: controller rev. 2.3
[    1.350375] UBI: attaching mtd3 to ubi0
[    1.354253] UBI: physical eraseblock size:   131072 bytes (128 KiB)
[    1.360918] UBI: logical eraseblock size:    126976 bytes
[    1.366344] UBI: smallest flash I/O unit:    2048
[    1.371203] UBI: sub-page size:              512
[    1.375847] UBI: VID header offset:          2048 (aligned 204
[    1.382008] UBI: data offset:                4096
[    1.570169] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 237:0, read 64 bytes
[    1.581136] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 238:0, read 64 bytes
[    1.592096] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 239:0, read 64 bytes
[    1.603053] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 240:0, read 64 bytes
[    1.614010] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 241:0, read 64 bytes
[    1.624973] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 242:0, read 64 bytes
[    1.635932] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 243:0, read 64 bytes
[    1.646889] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 244:0, read 64 bytes
[    1.657843] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 245:0, read 64 bytes
[    1.668799] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 246:0, read 64 bytes
[    1.679752] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 247:0, read 64 bytes
[    1.690777] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 248:0, read 64 bytes
[    1.701737] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 249:0, read 64 bytes
[    1.712695] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 by
tes from PEB 250:0, read 64 bytes
[    1.723652] UBI error: ubi_io_read: error -74 (ECC error) while reading 64 bytes from PEB 251:0, read 64 bytes[    1.734996] UBI warning: process_eb: valid VID header but corrupted EC header
at PEB 252
[    1.773555] UBI: max. sequence number:       0
[    1.778039] UBI error: ubi_read_volume_table: the layout volume was not found

[    1.785823] UBI error: ubi_init: cannot attach mtd3
[    1.793620] spi_davinci spi_davinci.0: Controller at 0xfec66000
[    1.850145] davinci_mdio davinci_mdio.0: davinci mdio revision 1.4
[    1.856369] davinci_mdio davinci_mdio.0: detected phy mask fffffffd
[    1.864671] davinci_mdio.0: probed
[    1.868134] davinci_mdio davinci_mdio.0: phy[1]: device 0:01, driver unknown
[    1.877525] i2c /dev entries driver
[    1.884231] Linux media interface: v0.10
[    1.889081] Linux video capture interface: v2.00
[    1.896710] vpbe-osd vpbe-osd: OSD sub device probe success
[    1.903632] vpbe-venc vpbe-venc: VENC sub device probe success
[    1.910989] vpbe-v4l2 vpbe-v4l2: vpbe v4l2 device registered
[    1.916903] Setting default output to Composite
[    1.921668] Setting default mode to ntsc
[    1.925744] vpbe-v4l2 vpbe-v4l2: Trying to register VPBE display device.
[    1.932643] vpbe-v4l2 vpbe-v4l2: layer=c2875400,layer->video_dev=c28754e8
[    1.940911] vpbe-v4l2 vpbe-v4l2: Trying to register VPBE display device.
[    1.947649] vpbe-v4l2 vpbe-v4l2: layer=c2875200,layer->video_dev=c28752e8
[    1.957257] watchdog watchdog: heartbeat 60 sec
[    1.969504] Error: Driver 'davinci-mcbsp' is already registered, aborting...
[    1.981042] asoc: cq93vc-hifi <-> davinci-vcif mapping ok
[    1.992202] ALSA device list:
[    1.995252]   #0: DaVinci DM365 EVM
[    2.000690] nf_conntrack version 0.5.0 (703 buckets, 2812 max)
[    2.009054] ip_tables: (C) 2000-2006 Netfilter Core Team
[    2.015152] TCP cubic registered
[    2.018425] NET: Registered protocol family 17
[    2.036328] VFS: Cannot open root device "ubi0:rootfs" or unknown-block(0,0)
[    2.043812] Please append a correct "root=" boot option; here are the availab
le partitions:
[    2.052426] 1f00            3072 mtdblock0  (driver?)
[    2.057534] 1f01            2048 mtdblock1  (driver?)
[    2.062798] 1f02            4096 mtdblock2  (driver?)
[    2.067894] 1f03           40960 mtdblock3  (driver?)
[    2.073100] 1f04            8192 mtdblock4  (driver?)
[    2.078195] 1f05           40960 mtdblock5  (driver?)
[    2.083394] 1f06           31744 mtdblock6  (driver?)
[    2.088483] Kernel panic - not syncing: VFS: Unable to mount root fs on unkno
wn-block(0,0)
[    2.096826] Backtrace:
[    2.099309] Function entered at [<c002e518>] from [<c02e1320>]
[    2.105219]  r7:00008000 r6:c2813000 r5:c0024318 r4:c037a240
[    2.111010] Function entered at [<c02e1308>] from [<c02e138c>]
[    2.116858] Function entered at [<c02e1324>] from [<c0008f8c>]
[    2.122749]  r3:00000000 r2:00000000 r1:c2825f78 r0:c0302bb5
[    2.128478] Function entered at [<c0008d28>] from [<c00090e4>]
[    2.134371] Function entered at [<c0009050>] from [<c00084b4>]
[    2.140260]  r5:c0023ab4 r4:c0379a58
[    2.143876] Function entered at [<c00083a4>] from [<c00433cc>]
[    2.149720]  r5:c00083a4 r4:00000000



以上是 启动日志，哪位高手能帮帮忙解释下，刚刚接触LINUX内容，好菜鸟的，大家帮帮忙

812412648

求大神回帖