centos为什么ifconfig命令中没有inet addr项？？

xender

[root@localhost ~]# ifconfig
eno1: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 154.211.6.27  netmask 255.255.255.0  broadcast 154.211.6.255
        inet6 fe80::225:90ff:fed4:49f4  prefixlen 64  scopeid 0x20<link>
        ether 00:25:90:d4:49:f4  txqueuelen 1000  (Ethernet)
        RX packets 121820519  bytes 9712606298 (9.0 GiB)
        RX errors 0  dropped 326207  overruns 0  frame 0
        TX packets 1403786  bytes 99842523 (95.2 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
        device memory 0xdf920000-df93ffff  

eno2: flags=4099<UP,BROADCAST,MULTICAST>  mtu 1500
        ether 00:25:90:d4:49:f5  txqueuelen 1000  (Ethernet)
        RX packets 0  bytes 0 (0.0 B)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 0  bytes 0 (0.0 B)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0
        device memory 0xdf900000-df91ffff  

lo: flags=73<UP,LOOPBACK,RUNNING>  mtu 65536
        inet 127.0.0.1  netmask 255.0.0.0
        inet6 ::1  prefixlen 128  scopeid 0x10<host>
        loop  txqueuelen 1000  (Local Loopback)
        RX packets 2721738  bytes 1066069911 (1016.6 MiB)
        RX errors 0  dropped 0  overruns 0  frame 0
        TX packets 2721738  bytes 1066069911 (1016.6 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0


如果希望显示inet addr项，如何应该操作？

xuebabybaby

mark.我是菜鸟路过。不知道

renxiao2003

现在分V4和V6，是不是去年了Address字样了。