P630机器报警，前面版上的叹号灯亮了急需解决

llqqff

PREVIOUSLY REPORTED PROBLEMS                                              801018

The Service Request Number(s)/Probable Cause(s)
(causes are listed in descending order of probability):

  651-880: The CEC or SPCN reported an error. Report the SRN and the following
           reference and physical location codes to your service provider.
           Error log information:
                 Date: Sat Nov 13 22:13:57 BEIST 2004
                 Sequence number: 275
                 Label: EPOW_SUS_CHRP
    Ref. Code: 10111521 FRU:  80P3677         U0.1-V2

patrick_peking

先查80P3677是什么吧！我也是菜鸟不好意思～

kolor

先看看errpt里面的东西，一般都有 PH的告警，如果确定硬件故障已经解决。最好是停应用。做diag>;enter>;task selection>;log repair action，ok

llqqff

我在网上查到以下原因，不知道是否是电源的问题

CEC is an acronym for "Central Electronic Complex"
and SPCN stands for "System Power Control Network".

CEC,the word can associate with any IBM servers like p,z,i etc...It need not be regatta(p670/p690) term.

As the error message code 651-880 shows :This is due power problem V1/V2 from last line of copper slim message....This is a hint..only.

copper slim:U can call your IBM support for hardware and
can get resovled

ulimit

原帖由 "llqqff" 发表：
我在网上查到以下原因，不知道是否是电源的问题

CEC is an acronym for "Central Electronic Complex"
and SPCN stands for "System Power Control Network".

CEC,the word can associate with any IBM serve..........

你查的cec是670/690上的。

RS9000

你 正常停机，并拔掉电源，就会这样，掉电也会，不一定是错误，，如果什么都没发生过，检查下ERRPT，MAIL

peapeacat

10111512查service guide是power supply1有问题

peapeacat

10111512查service guide是power supply1有问题