- 论坛徽章:
- 0
|
又来临时抱佛脚了,请教s7a电源问题
10U:拔下坏模块后,必须在5分钟之内插入新电源模块,或空电源模块.
5分钟的时间包括换风扇的时间。超时会宕机。
Power Supplies and Power Supply Fan Assemblies (10 EIA-Unit I/O Drawer)
Notes:
1. The 10 EIA-Unit I/O Drawer can hold up to two power supplies. You can replace each supply separately. The removal and replacement procedures are the same for each power supply.
2. If the I/O Drawer has two power supplies and only one needs to be removed, you do not have to power down the system.
3. Each power supply has a test switch. See “Power Supply Test Switch Procedure (10 EIA-Unit I/O Drawer)” on page 9-43.
4. If your system has only one power supply, the unused power supply position must be filled with a power supply blank, which must have a power supply fan assembly attached to it.
5. You need a 6mm nutdriver to perform this procedure.
Removal DANGER
Do not attempt to open the covers of the power supply. Power supplies are not serviceable and are to be replaced as a unit.
Attention: Do not perform the hot-swap procedure for a power supply if the ambient temperature is greater than 32°C (90°F), as it can cause loss of data or data corruption.
Be sure that the replacement power supply is ready to install, as the 10 EIA-Unit I/O Drawer can encounter problems if the power supply is removed for longer than five minutes. |
|