ports装不上phoenix，请看看输出结果帮忙分析

memoza

我刚才用cvsup升级了代码树然后再安装的。

# make install clean
===>;  phoenix-0.5_4 is marked as broken: Phoenix only supports the ports versions of Perl. If you have installed a Perl port, and are getting this message, please make sure you have given the command 'use.perl port'..
===>;  Cleaning for unzip-5.50
===>;  Cleaning for zip-2.3_1
===>;  Cleaning for libiconv-1.8_2
===>;  Cleaning for ORBit-0.5.17
===>;  Cleaning for gettext-0.11.5_1
===>;  Cleaning for glib-1.2.10_8
===>;  Cleaning for gmake-3.80
===>;  Cleaning for imake-4.3.0
===>;  Cleaning for libtool-1.3.4_4
===>;  Cleaning for nspr-4.3
===>;  Cleaning for pkgconfig-0.15.0
===>;  Cleaning for jpeg-6b_1
===>;  Cleaning for lcms-1.09
===>;  Cleaning for libmng-1.0.5
===>;  Cleaning for png-1.2.5_2
===>;  Cleaning for freetype2-2.1.4
===>;  Cleaning for expat-1.95.6_1
===>;  Cleaning for Xft-2.1_7
===>;  Cleaning for fontconfig-2.1.93
===>;  Cleaning for gtk-1.2.10_9
===>;  Cleaning for XFree86-libraries-4.3.0_1
===>;  Cleaning for phoenix-0.5_4
#
我要怎样解决呢？

statue

phoenix-0.5_4 is marked as broken: Phoenix only supports the ports versions of Perl. If you have installed a Perl port, and are getting this message, please make sure you have given the command 'use.perl port'..

hdcola

需要你在命令行上输入
use.perl port

kinux

原帖由 "hdcola" 发表：
需要你在命令行上输入
use.perl port

说多点好不好, 我也想学一学...

memoza

原帖由 "hdcola" 发表：
需要你在命令行上输入
use.perl port

呵呵，我就是不知道在哪里加入，
请写详细点好吗。

hdcola

就在当时的命令行中输入哪句话就成了。

memoza

大哥，加在哪呀？
你就把它写出来吧

hdcola

命令行上直接当命令敲进去！！！！！

quakelee

在安装了ports里面的perl的情况下，输入use.perl port

memoza

[quote]原帖由 "hdcola"]命令行上直接当命令敲进去！！！！！[/quote 发表：


# perl.use port
perl.use: Command not found.
# perl.use
perl.use: Command not found.
# whereis perl
perl: /usr/bin/perl /usr/share/man/man1/perl.1.gz
#
没有 /usr/ports/***/perl

实在不知怎么办才好。

我上次安装就一点问题都没有。