修改正解文件后使用RNDC RELOAD命令不能生效

psuo

我使用过NSUPDAE后，发现直接修改正解文件不能生效了。
十分郁闷，通过NSUPDATE修改后的数据是保存在那里了？
请赐教！

diancn

Bv9ARM (9.3.3)
3.3.1.2有关于rndc的介绍
4.2.1
If you have to make changes to a dynamic zone manually, the following procedure will work: Disable dynamic updates to the zone using rndc freeze zone. This will also remove the zone’s .jnl file and update the master file. Edit the zone file. Run rndc thaw zone to reload the changed zone and re-enable dynamic updates.

9.4.0rc1也是支持rndc的这两个选项的。

9.2不支持rndc的这两个选项的。只能停下named再重启。
The zone files of dynamic zones cannot normally be edited by hand because they are not guaranteed to contain the most recent dynamic changes — those are only in the journal file. The only way to ensure that the zone file of a dynamic zone is up to date is to run rndc stop.

[ 本帖最后由 diancn 于 2006-12-30 10:19 编辑 ]

psuo

感谢diancn 兄赐教！