请教有关FAStT500的随机资料问题

lwp

FAStT500在使用前要用串口线登录设置ip地址，我在随机的资料中没有找到相关的资料，如登录密码，命令的使用方法等。随机资料中推荐采用DHCP的方法邦定ip地址，此方法太繁琐。不知那位大侠有命令行方式下进行设置的资料。

uniconch

不需要用dhcp，直接指定好了；命令好像是没有帮助的，登陆之后好像有个help
至于密码，我记得应该是资料里有的，不在manual就在release notes里面，好像是passwd

Forrest_Zhang

1.Connect a serial cable from one of the controllers to a system with a terminal emulator available.  Windows systems use HyperTerminal (V3) or later.  Setting: 9600 + 8 data bit + 1 stip bit + none parity + none flow control
2.Send a break signal (usually Ctrl+Break) until this message is displayed:
Press the space bar for baud rate within 5 seconds.
Press the space bar to ensure the correct baud rate
3.Send another break signal; the following message is displayed:
Press within 5 seconds:ESC for SHELL,BREAK for baud rate.
4.Press Escape to access the shell of the controller, then type the password:
infiniti <---FAStT500/700          password <--- FAStT200
5. netCfgShow shows the current network configuration,
6. netCfgSet changes
7.Assign an IP address to the controller.
8.Repeat procedure for the second controller
9.Reset storage server by turning the controller unit off and on.

lwp

还想问一个问题，serial cable有什么特殊要求？
“Reset storage server by turning the controller unit off and on. ”意思是关闭电源就会恢复原来的配置吗？

ibm6000

新配置

rrobin

那如果更换了新的控制器，那么有没有什么办法在不需要重启机器的前提下
就能重新设置回被更换控制器的IP？