- 论坛徽章:
- 0
|
bandwidth中包含了input 和output. 对于一个100M的网卡,如果运行在全双工模式下,linkspeed这个分母应该是100M还是200M?如果是半双工模式下,应该是50M还是100M? You are mixing up the concepts. Let me put it this way:
Half duplex is a one-lane street. A car can travel either from left to right or from right to left but no both at the same time. The speed limit of this street is 100km/h.
______________
----> or <------
______________
Full duplex is a two-lane street. Cars can travel from left to right and right to left at the same time. The speed limit is also 100km/h
_______________
------->
----------------------
<------------
_______________
If the one-lane street is not busy, you can drive your car from left to right at 100km/h and immediately drive it back at 100km/h. It is as fast as you travel on a two-lane street. However, if the one-lane street is busy, after you drive from left to right, you have to wait until there is no traffic. Then you can drive back at 100km/h. While on a two-lane street, you don't have to wait to drive back. In either scenarios, the maximum speed is always 100km/h. Full duplex is quicker not becuase of its speed but because of its width.
Hope this helps |
|