1、禁止域名解析,输入错误命令以后只显示“% Incomplete command.” cisco_2950: no ip domain-lookup 2、端口映射 将端口5的所有流量映射到端口7 cisco_2950: monitor session 2 source interface Fa0/5 monitor session 2 destination interface Fa0/7 ingress vlan 1 3、交换机之间级连端口的工作模式 int fa0/4 sw mode trunk 4、TRUNK简介 Trunk 类型的端口可以属于多个VLAN,可以接收和发送多个VLAN 的报文,一般用于交换机...
1、wl-cisco4506# 特权命令状态router#,这时不但可以执行所有的用户命令,还可以看到和更改路由器的设置内容。 2、 wl-cisco4506#configure terminal 进入全局设置状态 Enter configuration commands, one per line. End with CNTL/Z. wl-cisco4506(config)# 全局设置状态,设置路由器的全局参数 3、显示命令 任务 命令 查看版本及引导信息 show version 查看运行设置 show running-config 查看开机设置 show startup-conf...
本帖最后由 君子狼 于 2010-08-03 01:51 编辑 1、 接口下的bandwidth命令改变带宽值给上层协议如ospf、eigrp等参考,QOS是否也参考这个带宽? 2、 记得以前看到过说cisco设备接口的吞吐量仅有80%可用,有20%是为二层协议、路由协议等预留的,现在还是吗?还是我记错了? 如果是的话,什么命令可以调节这个值
1.在基于IOS的交换机上设置主机名/系统名: switch(config)# hostname hostname 在基于CLI的交换机上设置主机名/系统名: switch(enable) set system name name-string 2.在基于IOS的交换机上设置登录口令: switch(config)# enable password level 1 password 在基于CLI的交换机上设置登录口令: switch(enable) set password switch(enable) set enalbepass 3.在基于IOS的交换机上设置远程访问: switch(config)# interfac...