ChinaUnix.net
相关文章推荐:

NMI按钮是干什么

我的系统是unixware711,机器是HP DL380,跑业务的时候经常自己重新启动机器,备份数据库时,机器会 dump,只能重启。我检查syslog发现里面有如下信息: PANIC: Fatal nmi Interrupt Raw stack dump begins at 0xEE578904: 904 EE578C08 00000003 FFFF62A0 C020E5F8 00000001 C0433C48 EE578C08 00000003 924 00000000 C014E41F C020E5F8 EE578974 00000000 C8F36C00 F23FC1B0 00000000 944 00000080 F239A100 00000000 016F3401 0...

by lx_lx99 - 其他UNIX - 2005-12-01 09:52:56 阅读(1233) 回复(1)

相关讨论

freebsd的系统,dmesg看到这个日志: nmi ISA 20, EISA ff 有人碰到过吗? 是啥问题咋办?

by 猪仔很忙 - BSD - 2008-04-28 12:08:42 阅读(2138) 回复(3)

机器是IBM X345 系统是Windows 2003 Server 1CPU,512RAM,1DISK 现在问题是我已经把HBA卡拔出来了。可问题还是依旧。 一进BIOS进行设置就自动重启了! 这是什么原因? [ 本帖最后由 henry91 于 2007-1-26 14:17 编辑 ]

by henry91 - 服务器及硬件技术 - 2007-02-05 01:23:05 阅读(3938) 回复(3)

k_trap - Unexpected nmi in system mode! 请问这是什么错?

by bodycom - 其他UNIX - 2004-06-18 13:11:26 阅读(1797) 回复(1)

How do I know if an IRQ or Exception is firing? When the PC boots up, the PIC IRQ's are mapped to interrupts 8 to 15 and 70 to 77. So when your kernel boots up and you switch into protected mode, the PIC's remain unchanged, and the low 8 IRQ's end up corresponding to the same interrupt as CPU exceptions 8 to 15. If one of these fire off, you can test if its an CPU exception or IRQ by testing s...

by 蓝色键盘 - C/C++ - 2004-01-06 17:10:50 阅读(1498) 回复(0)

机器是HP DL380 G3 系统是SCO UNIX5.06 3个SCSI硬盘用RAID卡做的RAID5 在单用户模式用FSCK扫描硬盘大约10分钟后 出现以下错误: WARNING:Casm:nmi Handler has been called on processor 0! WARNING:Casm:nmi-Automatic Server Recovery timer expiration - Hour.0-7/26/2005 WARNING:Casm:Attempting to shutdown due to ASR timer expiration! WARNING:Casm:Benign nmi detected 然后机器自动重起。 这是什么...

by unixandmysql - 其他UNIX - 2005-12-30 08:52:47 阅读(1867) 回复(1)

最近在看watchdog的代码中看到,watchdog处理程序故障时,除了reboot系统外,还可能产生SMI,nmi以及SCI等中断。nmi中断的触发、执行、处理函数都能在内核代码中找到,还比较好理解。但SMI和SCI好像完全对从操作系统透明,对于它们的触发条件、如何触发、触发时执行什么处理函数等从内核代码中似乎很难分析出来? 不知哪位大侠有过这方面的经历,望指教

by kimyoung - 内核/嵌入技术 - 2006-05-30 15:49:17 阅读(2753) 回复(1)
by sccdthm666 - 其他UNIX - 2005-12-22 15:37:02 阅读(1909) 回复(3)

系统是sco unix 5.0.7 ,具体问题是: 开机到 boot : 时,boot 上面有2行字提示: nmi issued.check event log Press Esc key to turn off nmi or other key to reboot 我按 ESC 系统正常启动 到检测设备时提示: warning: idistributed:cannot handle interrupts from PCI device (handler F015CF68,device 2/0/0) 然后就死机了,系统停留在这里不动了 请各位高手帮忙,多谢

by 遥遥11 - 其他UNIX - 2004-10-08 09:59:29 阅读(1870) 回复(3)