RS6000无法启动，LED4BA00830 E1F1

jlttt

TYPE:RS6000 44P-170
故障描述：启动机器时提示：
21A00001
starting software

LED：4BA00830 E1F1
由于这是老机器，没有用户手册，在google上也没找到相关信息，所以发帖求助各位兄弟。

yuxiao_zhao

Does the system stop with code E1F2, E1F3, STBY or 4BA00830 displayed on the
operator panel?
NO Go to “Step 1540-3” on page 54.
YES If a second pair of memory DIMMs was removed, go to “Step 1540-4” on
page 54.
Chapter 3. Maintenance Analysis Procedures 53
If the system has only one pair of memory DIMMs, go to “Step 1540-8” on
page 56.

yuxiao_zhao

service guide里面关于这个错误有向导式的问答
lz最好自己找到service guide然后对着一个个排查

jlttt

我找到一个44P Model 270 Service Guide，类似于170，我从上面找到了如下信息。
21A00xxx SCSI DASD device errors
Notes:
1. Before replacing any system
components:
a. Ensure that the controller and
each device on the SCSI bus is
assigned a unique SCSI ID.
b. Ensure SCSI bus is properly
terminated.
c. Ensure SCSI signal and power
cables are securely connected
and not damaged.
2. The location code information is
required to identify the ID of SCSI
device failures as well as to indicate
the location of the controller to
which the device is attached.
3. Check below for the xxx value, the
xxx can stand for anything like 001,
002, 003 and so on. Ensure that the
suspected SCSI device is checked
out completely.

21A00001 Test unit ready failed - hardware Refer to the notes in error code
error. 21A00xxx.
1. Replace the SCSI device.
2. Replace the SCSI cable.
3. Replace the SCSI controller.

[ 本帖最后由 jlttt 于 2008-3-24 11:17 编辑 ]

yddll

隔行如隔山啊

http://publib.boulder.ibm.com/in ... 00_7044_44p_170.htm

jlttt

yddll ，太感谢你了。以后找IBM文档就基本能解决问题了。