MSA1500cs存储如何管理连接？

zl_chu

没有console 口？

noise

原帖由 尘飞扬_cq 于 2009-8-31 11:48 发表
一台MSA1500cs,在存储控制器上没有发现console口，没有rj45口，只有光纤接口。咨询800后回复只能通过ACU进行管理，难道一定要PC机通过HBA卡安装ACU后来连接么？那多不方便，现在也没有带HBA卡的PC机，只有两台r ...

给你发张图更直观些

chenliang

CONSOLE没配过，ACU好使

ytycy

原帖由 noise 于 2009-9-1 13:29 发表


给你发张图更直观些

我看到这两个口，RJ45线插不进去啊。

gesture

参看手册：
HP StorageWorks 1500 Modular Smart Array installation guide
Part number: 355901–005
Fifth edition: June 2007

rx2600上装ACU对ARRAY进行配置

To use the ACU-CLI to configure MSA storage, perform the following steps to install it on the servers:

1. Insert the Support Software CD in the CD-ROM drive of the server.
2. From the console, mount the CD-ROM drive and navigate to the /HPUXACUCLI/HP-UX directory
for your environment.
3. List the contents of the directory and identify the ACU-CLI depot file for your environment.
4. Copy the ACU-CLI depot file and its corresponding readme file to a temporary directory on the
server. For example:
# cp /HPACUCLI/HP-UX/IA64/HPACUCLI_IA_v7.47-1.depot .tmp
5. Install the ACU-CLI application using the swinstall command. For example:
# swinstall -s /tmp/HPACUCLI_IA_v7.47-1.depot
6. Remove the Support Software CD from the CD-ROM drive.

To start the ACU-CLI, do the following from the console: Navigate to the
/opt/compaq/hpacucli/bld directory, and then enter # ./hpacucli.