求助：移植blob到s3c44B0x时,编译出错

zhongtianhua

移植blob到44B0时,编译出错!!
平台 UP-NETARM3000,CPU:s3c44box, 交叉编译器是：arm-uclibc-gcc,内核版本：ARM7TDMI
[root@localhost blob-for3000]# configure -with-board=mba-44b0
checking for a BSD-compatible install... /usr/bin/install -c
checking whether build environment is sane... yes
checking whether make sets $(MAKE)... yes
checking for working aclocal... found
checking for working autoconf... found
checking for working automake... found
checking for working autoheader... found
checking for working makeinfo... found
checking whether to enable maintainer-specific portions of Makefiles... no
checking build system type... i686-pc-linux-gnu
checking host system type... i686-pc-linux-gnu
checking for arm-elf-gcc... arm-uclibc-gcc
checking for arm-elf-objcopy... arm-uclibc-objcopy
checking for arm-elf-ranlib... arm-uclibc-ranlib
checking for arm-elf-ar... arm-uclibc-ar
checking for C compiler default output... a.out
checking whether the C compiler works... configure: error: cannot run C compiled programs.
If you meant to cross compile, use `--host'.
See `config.log' for more details.
希望高手帮帮忙，谢谢了

[ 本帖最后由 zhongtianhua 于 2007-4-19 11:14 编辑 ]

yidou

"checking whether the C compiler works... configure: error: cannot run C compiled programs."

跟踪一下这句

zhongtianhua

我跟踪了，但是
checking whether to enable maintainer-specific portions of Makefiles... no，这一句就表明有错误，也不知道该改哪个地方，帮帮忙啊

visualj

一般情况下是gcc的版本问题导致的。