我得ultra5为什么又不启动了,好怪的现象

qinyf

启动时提示：
Fast Data Access MMU Miss
然后进入open boot

我用boot -s 启动同样不行，
用boot cdrom -s 启动后运行
fsck /dev/dsk/c0t0d0s0
提示：CONNOT SEEK: BLK 11000096
然后fsck退出

蓝冰

这个有用吗？在sunsolve站点上看到的。
PROBLEM #2
(see also SRDB 20149)

Enterprise Server systems that use the 400MHz UltraSPARC II with 8mb ecache CPU module(s) will fail to boot to Solaris 2.5.1 or Solaris 2.6 cdrom (or JumpStart image) with \"Fast Data Access MMU Miss\" and/or \"mutex_enter: bad mutex\". SRDB 20149 describes this problem and has the exact procedure to boot/load these systems with 2.5.1/2.6.

The problem is that the kernel on the 2.5.1/2.6 CD-ROM cannot load with the 400MHz/8MB ecache CPU until the kernel patch is loaded. The workaround (seen in the SRDB) is to run the command \"limit-ecache-size\" from the OK prompt before booting to the 2.5.1/2.6 cdrom or JumpStart image. It will be able to boot the cdrom or image immediately after this command is run. After the OS is loaded, you will need to run this command again from the OK prompt to boot the system until you load the latest kernel patch. Here are the systems (that potentially have the 400MHz 8mb cache cpu installed) affected by this problem:

        E3000        E3500        E4000
        E4500        E5000        E5500
        E6000        E6500                              
Only systems that have the 400MHz/8MB cache cpu(s) are affected

iricyan

导致Fast Data Access MMU Miss的原因很多！
首先你的硬盘好像有问题了！
备份数据，从新安装一下看看了！

vahmoiz

原帖由 \"qinyf\" 发表：
启动时提示：
Fast Data Access MMU Miss
然后进入open boot

我用boot -s 启动同样不行，
用boot cdrom -s 启动后运行
fsck /dev/dsk/c0t0d0s0
提示：CONNOT SEEK: BLK 11000096
然后fsck退出

一般是硬件出问题