IBM存儲連接錯誤訊息﹐如何處理﹖

Tomac

大家好﹕\r\nLINUX主機系統連接IBM磁盤陣列﹐配置RDAC后﹐啟動出現以下異常訊息。是否存在問題﹖一個朋友說沒有關系。我不確定。原來﹐我們一直被這些存儲搞的很累。\r\n謝謝﹗\r\n\r\n\r\n1\r\nSCSI subsystem initialized\r\nqla2xxx: Unknown parameter `ql2xfailover\'\r\nQLogic Fibre Channel HBA Driver\r\nAdaptec aacraid driver (1.1-5[2412])\r\nACPI: PCI interrupt 0000:11:03.0[A] -> GSI 24 (level, low) -> IRQ 50\r\naacraid0: kernel 4.2-0[7349]\r\naacraid0: monitor 4.2-0[7349]\r\naacraid0: bios 4.2-0[7349]\r\naacraid0: Non-DASD support enabled.\r\naacraid0: 64 Bit DAC enabled\r\nscsi0 : aacraid\r\n\r\n2\r\nata3: SATA link down (SStatus 0)\r\nscsi3 : sata_nv\r\nata4: SATA link down (SStatus 0)\r\nscsi4 : sata_nv\r\nqla2300: Unknown parameter `ql2xfailover\'\r\nACPI: PCI interrupt 0000:11:04.0[A] -> GSI 25 (level, low) -> IRQ 58\r\nqla2300 0000:11:04.0: Found an ISP2312, irq 58, iobase 0xffffff000001a000\r\n\r\n3 \r\nSCSI device sde: 419430400 512-byte hdwr sectors (214748 MB)\r\nSCSI device sde: drive cache: write back\r\n sde: unknown partition table\r\nAttached scsi disk sde at scsi7, channel 0, id 0, lun 3\r\nAttached scsi generic sg8 at scsi7, channel 0, id 0, lun 3,  type 0