How do I set up PowerPath for FC4500 array attached to HP-UX

emc2665

EMC  Clariion 4500 \r\n\r\nEMC SW: Navisphere 6.4\r\n\r\n\r\nStep 1 - Set systemtype or initiator type\r\n\r\nNon-Access Logix\r\n\r\nSet systemtype to A using the following command:\r\n\r\nnavicli -d <controller number>; systemtype -config a\r\n\r\nNote:  This will cause the array to reboot.\r\n\r\nAccess Logix\r\n\r\nSet initiator type to no AutoTrespass by commenting the following entry in the agent.config file:\r\nExample: # OptionsSupported AutoTrespass \r\nStop and start the Navisphere host Agent. \r\nStep 2 - Set arraycompath and failover mode for non-Access-Logix and Access Logix:\r\n\r\nNon-Access Logix\r\n\r\nUse the following commands:\r\n\r\nnavicli -d <controller number>; arraycommpath 1 -host <hostname>;\r\n\r\nnavicli -d <controller number>; failovermode 1 -host <hostname>;\r\n\r\n-or-\r\n\r\nnavicli -d <controller number>; arraycommpath 1 -ip <host IP address>;\r\n\r\nnavicli -d <controller number>; failovermode 1 -ip <host IP address>;\r\n\r\n \r\n\r\nAccess Logix\r\n\r\nUse the following commands:\r\n\r\nnavicli -d <controller number>; storagegroup -sethost -arraycommpath 1 -host <hostname>;\r\n\r\nnavicli -d <controller number>; storagegroup -sethost -failovermode 1 -host <hostname>;\r\n\r\n-or-\r\n\r\nnavicli -d <controller number>; storagegroup -sethost -arraycommpath 1 -ip <host IP address>;\r\n\r\nnavicli -d <controller number>; storagegroup -sethost -failovermode 1 -ip <host IP address>;