- 论坛徽章:
- 0
|
安装完后出现下面的提示
The installation operation can provide brief or detailed descriptions. If you need to return the target system to its original state,am In either case, you can request the detailed descriptions by typing "?". you may need to restore yo Do you always want detailed descriptions? (Yes/No) [No]
%PCSI-E-OPENOUT, error opening DISK$ALPHASYS:[VMS$COMMON.][VUE$LIBRARY.SYSTEM]SO UND$PROFILE.VUE$DAT;* as output -RMS-E-DNF, directory not found -SYSTEM-W-BADIRECTORY, bad directory file format %PCSI-E-OPFAILED, operation failed Terminating is strongly recommended. Do you want to terminate? [YES]
%PCSI-E-CANCEL_WIP, termination resulted in an incomplete modification to the sy stem %PCSI-E-S_OPCAN, operation cancelled by request %PCSIUI-E-ABORT, operation terminated due to an unrecoverable error condition Installation has been aborted. The installation has not completed normally.
回答 NO不行，回答yes后，进入了最先的安装菜单
1) Upgrade, install or reconfigure OpenVMS Alpha Version V7.3
2) Display products and patches that this procedure can install
3) Install or upgrade layered products and patches
4) Show installed products
5) Reconfigure installed products
6) Remove installed products
7) Execute DCL commands and procedures
选择8 重起后，输入 b 后出现上面的东西
硬盘是dqa0
>;>;>;b
(boot dqa0.0.0.13.0 -flags 0)
block 0 of dqa0.0.0.13.0 is a valid boot block
reading 936 blocks from dqa0.0.0.13.0
bootstrap code read in
base = 200000, image_start = 0, image_bytes = 75000(479232)
initializing HWRPB at 2000
initializing page table at 1ff32000
initializing machine state
setting affinity to the primary CPU
jumping to bootstrap code
%APB-I-FILENOTLOC, Unable to locate SYSBOOT.EXE
%APB-I-LOADFAIL, Failed to load secondary bootstrap, status = 00000870
halted CPU 0
halt code = 5
HALT instruction executed
PC = 20003c54
warning -- HWRPB is invalid
>;>;>;
赶着交货，知道的朋友帮帮忙，先谢了！！ |
|
免费注册
发表于 2005-01-23 23:51
