如何对CISCO交换机进行SNMP管理

lrxiang

我们单位有几台CISCO2950、2924的交换机，我也搞到一套SNMP软件，但是不知道要对CISCO交换机进行SNMP管理，在交换机上需要进行哪些设置？有什么需要注意的地方？

xliu

要开启SNMP服务，别的好像没有什么要设置的。

Lambent

Assign a management VLAN, let's say VLAN 1

assign an IP address on interface VLAN1

!
interface VLAN 1
ip address 10.0.0.1 255.255.255.0
!

Assuming your SNMP server is in the same management VLAN, assign an IP address for your server, let's say 10.0.0.100/24

then on the switch, use the following commands to turn on SNMP (assuming the read-only and read/write community strings on both the switch and the server are ABC and DEF respectively):

!
snmp-server community ABC ro
snmp-server community DEF rw
snmp-server trap-source VLAN 1
snmp-server location yourlocation
snmp-server chassis-id routerhostname
snmp-server enable traps
snmp-server host 10.0.0.100 DEF snmp
!


I cannot type chinese, sorry about that.