【求助】单位一台cisco2611不断报告Ethernet0/1 transmit error怎么办?

tomorrower

--------------------------------------------------------------------------------
不断通过syslog报告以下信息:
17:22 10.138.12.174 Notice 895: 2w6d: Ethernet0/1 transmit error

cisco2611#sh int e0/1
Ethernet0/1 is up, line protocol is up
Hardware is AmdP2, address is 0007.0eaf.f441 (bia 0007.0eaf.f441)
Internet address is 10.238.*.*/29
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:07:03, output 00:00:00, output hang never
Last clearing of "show interface" counters 01:48:39
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
256 packets input, 31919 bytes, 0 no buffer
Received 6 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
1015 packets output, 107084 bytes, 0 underruns(0/0/0)
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out