Cisco1841如何配置桥接???

chensky004

请教下,我是刚刚开始配置cisco设备的,现在遇到一个问题. 公司一个分部与另一分部是通过 SDH专线路连接两端接上光端机后再接上cisco1841的路由器, 设好IP做个桥接.. 做桥接时s0口与F0口都是设同一个网段的IP, 然后加入到一个桥接组.两边是同样的设置,只是IP不一样. 下面是配置方法,看哪里出错现在双方的PC就是不能访问对方.
User Access Verification

Password:
KWE.DZ.Bridge.01#show run
Building configuration...

Current configuration : 2000 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname KWE.DZ.Bridge.01
!
boot-start-marker
boot-end-marker
!
logging buffered 51200 warnings
enable password ****
!
no aaa new-model
!
resource policy
!
mmi polling-interval 60
no mmi auto-configure
no mmi pvc
mmi snmp-timeout 180
ip subnet-zero
ip cef
!
!
no ip dhcp use vrf connected
!
!
ip domain name yourdomain.com
!
!
bridge irb
!
!
interface FastEthernet0/0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-FE 0$
no ip address
duplex auto
speed auto
bridge-group 1
!
interface FastEthernet0/1
no ip address
duplex auto
speed auto
!
interface Serial0/0/0
description connect KWE to DZ
no ip address
bridge-group 1
!
interface BVI1
ip address 128.250.9.53 255.255.0.0
!
ip classless
!
ip http server
ip http authentication local
ip http timeout-policy idle 60 life 86400 requests 10000
!
!
control-plane
!
bridge 1 protocol ieee
bridge 1 route ip
banner login ^C
-----------------------------------------------------------------------
Cisco Router and Security Device Manager (SDM) is installed on this device.
This feature requires the one-time use of the username "cisco"
with the password "cisco". The default username and password have a privilege le
vel of 15.

Please change these publicly known initial credentials using SDM or the IOS CLI.

Here are the Cisco IOS commands.

username <myuser>  privilege 15 secret 0 <mypassword>
no username cisco

Replace <myuser> and <mypassword> with the username and password you want to use
.

For more information about SDM please follow the instructions in the QUICK START

GUIDE for your router or go to http://www.cisco.com/go/sdm
-----------------------------------------------------------------------
^C
!
line con 0
line aux 0
line vty 0 4
privilege level 15
password test
login
transport input all
line vty 5 15
access-class 23 in
privilege level 15
login local
transport input telnet
!
end

KWE.DZ.Bridge.01#