- 论坛徽章:
- 0
|
prc_sync: script (S##name) failed to complete in 120 seconds
Cause
The script is not able to finish in the allotted time given for execution. The file /etc/rc2 contains the default time for each script to execute. If a script cannot terminate within this time frame, the system is notified.
Solution
Follow these steps:
- Go to the /etc directory:
#cd /etc
- With your favorite editor, edit the rc2 file.
- Search for the line:
/etc/prc_sync /etc/rc2.d 120 start
- Change the 120 to a higher number, for example, 300. This should give the script sufficient time to execute. If this is still not enough time, you can re-edit the file to increase the number.
Note
If increasing the time the script takes to execute does not resolve the problem, this is an indication that there is something else preventing the script to fully execute. In this case, you will need to set the debug flag in the script to further analyze what is causing the problem.
To set the debug flag, edit the shell script file with your favorite editor. Add the following on the first uncommented line:
set -x
Setting the debug flag in the script file will not display the debug information to the screen. The information gets saved in the /etc/rc2.d/messages/script_file_name.log. Since the script does not terminate, you will need to reboot, go into single-user mode and take a look at the file. |
|
免费注册
发表于 2007-07-10 11:20
