[求助]ADSL上网及宽屏问题

weilliam

1、ADSL上网的问题。  按HandBook及参考网友提供的方法对/etc/ppp/ppp.conf配置好后，进行拨号

#ifconfig
rl0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
        options=8<VLAN_MTU>
        inet 192.168.1.2 netmask 0xffffff00 broadcast 192.168.1.255
        ether 00:19:e0:06:c8:05
        media: Ethernet autoselect (100baseTX <full-duplex>
        status: active
pflog0: flags=0<> mtu 33208
pfsync0: flags=0<> mtu 2020
        syncpeer: 224.0.0.240 maxupd: 128
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
        inet6 fe80::1%lo0 prefixlen 64 scopeid 0x4
        inet6 ::1 prefixlen 128
        inet 127.0.0.1 netmask 0xff000000
tun0: flags=8051<UP,POINTOPOINT,RUNNING,MULTICAST> mtu 1492
        inet 124.161.21.98 --> 124.161.21.1 netmask 0xffffffff
        Opened by PID 87
而且
#ping 124.161.21.1
也能通，但就是上不去网，包括124.161.21.1(www.169ol.com)
查看/var/log/ppp.log
Aug 19 17:00:00 freebsd newsyslog[994]: logfile turned over due to size>100K
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: Received NGM_PPPOE_ACNAME (hook "CD169-CDHSXQ-MA5200F-PPPOE"
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: Received NGM_PPPOE_SESSIONID
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: Received NGM_PPPOE_SUCCESS
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: deflink: carrier -> login
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: deflink: login -> lcp
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: bundle: Authenticate
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: deflink: his = CHAP 0x05, mine = none
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: Chap Input: CHALLENGE (16 bytes)
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: Chap Output: RESPONSE (ADSL198228233)
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: Chap Input: SUCCESS (Welcome to use Quidway ROUTER, Huawei Tech.^M )
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: deflink: lcp -> open
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: bundle: Network
Aug 19 17:22:51 freebsd ppp[310]: tun0: Phase: deflink: IPV6CP protocol reject closes IPV6CP !
Aug 19 17:23:03 freebsd last message repeated 5 time

2、支持宽屏问题

按网友提供的方法在内核配置文件中添加
device  drm  # DRM core module required by DRM drivers
device  r128drm  # ATI Rage 128
device  radeondrm # ATI Radeon
options   VESA
options   SC_PIXEL_MODE
重新编译内核，重启。
在/etc/X11/xorg.conf中选用VESA驱动
并把显示模式改为
Modes "1440x900"
运行startx进入KDE后的分辨率却是1600x1200，其他可选的为1440x1050,1280x1024,1152x864，就是没有1440x900
如果把显示模式改为
Virtual 1440 900的话却是花屏。

/var/log/Xorg.0.log中显示是应该能够支持1440x900的，以下是其中的支持信息
(II) VESA(0): Manufacturer's mask: 0
(II) VESA(0): Supported Future Video Modes:
(II) VESA(0): #0: hsize: 1280  vsize 1024  refresh: 60  vid: 32897
(II) VESA(0): #1: hsize: 1280  vsize 960  refresh: 60  vid: 16513
(II) VESA(0): #2: hsize: 1152  vsize 864  refresh: 75  vid: 20337
(II) VESA(0): #3: hsize: 1440  vsize 900  refresh: 60  vid: 149
(II) VESA(0): Supported additional Video Mode:
(II) VESA(0): clock: 106.5 MHz   Image Size:  408 x 255 mm
(II) VESA(0): h_active: 1440  h_sync: 1520  h_sync_end 1672 h_blank_end 1904 h_border: 0
(II) VESA(0): v_active: 900  v_sync: 903  v_sync_end 909 v_blanking: 934 v_border: 0
(II) VESA(0): Ranges: V min: 56  V max: 76 Hz, H min: 30  H max: 82 kHz, PixClock max 140 MHz
(II) VESA(0): Monitor name: Acer AL1916W
(II) VESA(0): Serial No: ETL5209019


本人刚由Ubuntu转入FreeBSD，水平很菜！

期待高手帮忙，先谢了！

注：附件为完整的Xorg.0.log，系统为AMD sp2800＋1GRAM＋wd250G＋NF5D＋ATI Radeon X550XT＋acer AL1916W  win2k＋Ubuntu7.04＋FreeBSD6.2 Release，成都网通ADSL拨号上网，在Ubuntu和win2k下都能上网。

weilliam

呵呵……
这么长时间也没人帮忙整一下。

宽屏的问题没有解决，但上网的问题解决了，利用Ubuntu下的resolv.conf替换FB的resolv.conf就OK了，原来是nameserver没弄对。