ChinaUnix.net
相关文章推荐:

debian ip

debian中设置ip debian 503版本。 vhost:/# cd /etc/network vhost:/etc/network# vi interface # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback # The primary network interface auto eth0 iface eth0 inet static address 203.171.237.2...

by wbzh - Linux文档专区 - 2009-10-14 20:25:00 阅读(1039) 回复(0)

相关讨论

作者: dzajk 出自: http://www.linuxdiyf.com 1. ip地址设置 debian:~#vi /etc/network/interfaces // 动态DHCP获得 # 启动系统激活设备. # Loop回环地址. auto lo iface lo inet loopback # 启动系统激活设备. # 网卡eth0设置为DHCP类型. auto eth0 iface eth0 inet dhcp // 静态Static获得 # 启动系统激活设备. # Loop回环地址. auto lo iface lo inet loopback # 启动系统激活设备. # 网卡eth0设置为Static类型. auto eth0 if...

by sdccf - Linux文档专区 - 2008-04-26 14:19:21 阅读(742) 回复(0)

以root身份运行,然后修改 /etc/network/interfaces这个文件,可以设置ip auto eth0 iface eth0 inet static address 192.168.1.7 netmask 255.255.255.0 network 192.168.1.0 broadcast 192.168.1.255 gateway 192.168.1.1 dns-nameservers DNSip #此处可以不设,而是在/etc/resolv.conf中设置。 设置DNS服务器 #cat /etc/resolv.conf nameserver 61.177.7.1 nameserver 202.102.14.141 本文来自ChinaUnix博客,如果查看原文请点...

by linyin - Linux文档专区 - 2009-01-16 01:04:04 阅读(1087) 回复(0)

shell@debian:~$ cat /etc/resolv.conf # Generated by NetworkManager nameserver 192.168.1.1 nameserver 192.168.0.1 shell@debian:~$ shell@debian:~$ 请问手动修改后,重启后会不会被覆盖???我就是想持久修改的,谢谢 shell@debian:~$ lsb_release -a No LSB modules are available. Distributor ID: debian Description: debian GNU/Linux 8.7 (jessie) Release: 8.7 Codename: jessie shell@debian:~$ ...

by action08 - Linux系统管理 - 2017-04-26 17:18:56 阅读(1169) 回复(3)

小弟初学linux,这几天发现/etc/network/intaerfaces配置文件中无wlan0的配置内容,但ifconfig命令能显示wlan0有ip相关的配置内容。请问这是为什么?请问wlan0的ip配置要去哪个文件中找到?

by wolfxjc - Linux新手园地 - 2013-04-01 23:46:52 阅读(1313) 回复(3)

如我的ip是192.168.0.2 是怎么上呢? 偶用 ifconfig eth0:1 192.168.0.2 netmask 255.255.255.0 up 还是联不上。 谢谢~~~~

by control818 - Linux新手园地 - 2008-11-27 23:24:30 阅读(1811) 回复(5)

以 root 用户账号执行以下命令。假设你的网卡设备是 eth0,要修改为 ip 地址 172.16.1.100 子网掩码 255.255.255.0 默认 路由 172.16.1.254 /sbin/ifconfig eth0 172.16.1.100 broadcast 172.16.1.255 netmask 255.255.255.0 route add default gw 172.16.1.254 本文来自ChinaUnix博客,如果查看原文请点:http://blog.chinaunix.net/u/8862/showart_163214.html

by akezor - Linux文档专区 - 2006-08-31 21:39:47 阅读(809) 回复(0)

个人比较喜欢nano,因为vi在我的系统上总是有问题 nano /etc/network/interfaces 照上边eth0添加eth0:0 auto eth0 iface eth0 inet static name Ethernet Lan card address 192.168.0.1 netmask 255.255.255.0 network 192.168.0.0 broadcast 192.168.0.255 gateway 192.168.0.254 auto eth0:0 iface eth0:0 inet static name Ethernet Lan card address 192.168.0.2 netmask 255.255.255.0 network 192.168.0....

by anhongkui - Linux文档专区 - 2006-07-03 13:51:00 阅读(807) 回复(0)

本帖最后由 royzs 于 2012-09-21 14:05 编辑 [code] # This file describes the network interfaces available on your system # and how to activate them. For more information, see interfaces(5). # The loopback network interface auto lo iface lo inet loopback # The primary network interface auto eth0 allow-hotplug eth0 iface eth0 inet dhcp address 192.168.1.12 netmask 255.255.255.0 network 192.168.1....

by royzs - Linux新手园地 - 2012-09-21 13:39:07 阅读(5785) 回复(15)

debian8中,使用dhcp自动获取ip,现在的问题是如果保持开机一晚上不关,第二天就会发现ip丢失,而且dhclient会失败,求解释。环境是vmware 10+桥接

by dacheng - Linux系统管理 - 2015-07-01 08:54:42 阅读(561) 回复(0)

我的无线网卡是 01:00.0 Network controller: Intel Corporation Centrino Ultimate-N 6300 (rev 35) 系统是debian6.0 squeeze X86系统 lsmod | grep iw 中 已经加载了无线网卡的驱动 iwlagn 73139 0 iwlcore 77810 1 iwlagn mac80211 137340 2 iwlagn,iwlcore led_class 2433 1 iwlcore cfg80211 101496 3 iwlagn,iwlcore,mac80211 ...

by 黑腾小于 - Linux系统管理 - 2012-07-26 10:06:50 阅读(5647) 回复(10)