no link presentcheck cable
How to check cable link staus and ndd usage? checking link status with ndd # ndd -set /dev/qfe instance 0 (instance set to "0" checks qfe0 status; "1" for qfe1,etc...) # ndd /dev/qfe link_status 1 ( 1 -up, 0 = down -------------------- ndd /dev/hme ? # list all the parameters for the hme drivers ndd dev/hme link_speed # output the link speed; 0 is 10M, ...
by pianoch - Solaris文档中心 - 2005-09-28 10:56:16 阅读（991） 回复（0）
Nx-link Data cable - Fibre Channel 型号 规格 250772-003M Fibre Optic cable, LC LC, short wave, 3 meters 250772-005M Fibre Optic cable, LC LC, short wave, 5 meters 250772-010M Fibre Optic cable, LC LC, short wave, 10 meters 250772-025M Fibre Optic cable, LC LC, short wave, 25 meters 250772-050M Fibre Optic cable, LC LC, short wave, 50 meters GBIC & SFP Media 型号 规格 Finisar FTRJ-8519-7...
前些天有台sun250出问题了
http://bbs.chinaunix.net/viewthread.php?tid=910482&extra=page%3D1,
到现在还没弄好!
用笔记本终于进了系统,除了报c0t0d0s7没mount外,可以正常进系统了!
solaris 8
#ifconfig -a
lo0: flags=849
显示Sunw ,hme0:link down-cable problems? 可是网线没问题啊？问题在哪？？？？ :(
Null Modem cable After all, isn't this why you came to this site? The purpose of a null-modem cable is to permit two RS-232 "DTE" devices to communicate with each other without modems or other communication devices (i.e., "DCE"s) between them. To achieve this, the most obvious connection is that the TD signal of one device must be connected to the RD input of the other device (and vice versa)...
当我开机运行indy的时候,系统diagnostic后出现一下问题 SCSI device/cable diagnostic *FAILED* check or replace:Disk, Floppy,CDROM or SCIS cable disk0d10 Device not ready: Unit not ready disk0d10 Device not ready: Unit not ready disk0d10 Device not ready: Unit not ready disk0d10 Device not ready: Unit not ready disk0d10 Device not ready: Unit not ready Diagnostic failed 然后我试图从新安装操作系统...
Low voltage differential SCSI cable,68 pin high density (M) to 68 pin high density (M),有货者请回贴或mail至forconiverse@hotmail.com,谢谢.地点:上海
