ChinaUnix.net
相关文章推荐:

断电开机时间清零

如题:指教 看文档 sccli 下 可以使用 show battery-status -u 参数自动更新 可惜不成 ,不知道为什么? 在sccli下如何给双控制器升级fireware呢? 大家再帮我看看这段话: When a Battery Board is installed as part of a Controller FRU,if you do not reset and verify the in-service date, Sun StorEdge Configuration Service and the Sun StorEdge CLI cannot accurately calculate the battery expiration date   ...

by westlife521 - Solaris - 2010-08-19 14:36:28 阅读(3165) 回复(18)

相关讨论

在>模式下 reset counters interface 本文来自ChinaUnix博客,如果查看原文请点:http://blog.chinaunix.net/u1/43842/showart_491159.html

华为

by yangly - 网络技术文档中心 - 2008-03-07 11:35:59 阅读(794) 回复(0)

在动态IP上网的机器上,开机在检查eth0(网卡号)时会耗掉很长的时间,这次我重装了系统后,没有选择开机就激活网卡,这样的开机时间大大的减少了,我的LINUX现在比2K还启动得快了!真爽!但是上网是个问题!特别是网卡的激活! 前几天也发了不少的帖子,多谢各位的作答!现在我把整个方法说明如下!真是花了不少的时间来得出这个方法,快!还请各位指正! 1.把/etc/sysconfig/network-scripts/ifcfg-eth0 (如果是别的网卡,查看相应的文件)文件中的O...

by wqch - Linux论坛 - 2003-04-26 10:08:42 阅读(418) 回复(0)

:em16: :shock: :shock: :shock: :shock:

by yueliangdao0608 - 版主会议室 - 2009-11-12 22:56:10 阅读(41) 回复(4)

/0 /1 /2 /3 /4 /5 /6 /7 /8 /9 /10 Load Average | Interface Traffic Peak Total lo0 in 22.906 KB/s 185.236 KB/s 7.294 GB out 22.906 KB/s 185.236 KB/s 7.294 GB re0 in 13.347 KB/s 17.334 KB/s 1.947 GB o...

by sfzzz - BSD - 2009-08-11 12:57:03 阅读(1618) 回复(3)