- 论坛徽章:
- 1
|
http://unix-cd.com/vc/www/24/2009-12/14583.html
1、 利用SCO UNIX 附带的启动盘启动计算机。
2、 在屏幕出现：
<eServer LSI Ultra 320 SCSI 卡驱动程序（For SCO OpenServer 5.06) v1.02>;{制作一张SCSI设备得盘,随机光盘制作,scsi驱动下载http://www-900.ibm.com/cn/suppor ... l?DocId=JJIG-5E2AFQ
Sco OpenServer(TM) Release 5
Boot
: defbootstr link=”lsil” Srom=wd(0,0,0,0)敲回车 （可选）
3、 SCO UNIX 载入所有关安装信息当显示Press<ENTER>;to begin installation时
请检查屏幕上硬件项中是否有%cd-rom项，如不存在返回2重新定义或更换
CD—ROM直到找到为止。
4、 接着按系统默认值安装，出现：
Media device to be used : IDE CD ROM (按空格可选)
IDE controller: Secondary
Master or Slave: master
注意：如第2步已定义好此处无须改动。
敲Accept above choices-----àOK-----àAccept above choices---
5、 Licensing your System
License number :
License code :
License date :
注意：务须按产品提供的序列号，敲Accept above choices--à6
6、 Suitability for automatic
Upgrade Fresh
说明：如升级选Upgrade（要求5.0以上版本），覆盖或完全安装选Fresh
一般选Fresh。
敲Fresh----OK---7、 Configuring the basic system
System name : scosysv
Domain name :
Security profile : raditiona
Time zone : Eastern Standard/Summer time ----à按空格选择---à8
8、 Time Zone
Geographical area : 按空格选--Asia
Asia time zone : 按空格选---àChina Standard Time(CTS)
Daylight Saving time : User must set after installation
敲Accept above choices----à7-----àAccept above choices---->;9
9、Initial system profile
Database serrvices : NO按空格选--->;Yes
敲Accept above choices--->;10
10、Preparing your disk an choosing software
Hard disk setup : UNIX only : Bad Traching ON 按空格
出现：
Setting up your hard disk
Disk 0 ; 4094MB.Partitions&filesystem : Use whole disk for Unix
按空格选择---->;customize--->;11
Disk 0 bad track type : Thorough/destructive按空格选择--->;Yes-->;12
11、硬盘分区，系统区/u和数据区/data
Customizing Partitions & filesystem
Total available space on disk : 4096
Size of unix partition : 4096
DOS partition :
OTHER partition :
Unix devisions&filesystems
Name Mount point Size(in MB) Type
0 boot /stand 15 EAFS
1 swap 64 NOFS(一般定义为内存的倍数)
2 root / 2014 HTFS
3 0 HTFS
4 recover 1 NOFS
敲Appect above choices--->;10
12、 * WARNING *
The entire contents of your hard disk will be ereased.
Are your sure you want to erase the conteats of the disk
Yes No
选择Yes---->;Accept above choices--->;13
13、Preparing your dis and choosing software
Hard disk : Layout now customized : Bad Tracking OFF
Optional software : Sco Openserver Enter prise system,256MB按空格可选
敲-->;Accept above choices-----14
14、The installation can now proceed unattended.
Select ok to continue.select cancel to review
or change your answers.
OK Cancel
敲OK
15、到此SCO UNIX 自动安装，结束重启计算机。
16 、安装网卡: 复制网卡驱动
#mount /dev/fd0 /mnt
#cp net /tmp/VOL.000.000
<net为网卡的驱动,已经备份到软盘>;
17 、# scoadmin
software manager à software à Install New Software à select “scosysv” 在Media Device 下用空格select “Floppy disk” continue à读盘后屏幕出现“Hewlett-Packard Network Drivers (ver 1.4.6)”select “Install”出现“Installation complete”选择<OK>;
Networks Network configuration manager hardware Add new adapter à找到“新添加的驱动”continue Add protocol时选择相应协议”Add”按照相应协议要求输入相应项目Configuration networking product “The following products were successfully configured into the system sco TCP/IP”
BCM570x-based ,重新连接核心并重启系统。 |
|
免费注册
发表于 2009-12-21 23:02
