How to force iprb to run at 100fdx

南非蜘蛛

Since the interface does not show up in the output of prtconf, you will set the instance based on ifconfig output.
Instance refers to the interface #.
iprb0 -->; instance 0
iprb1 -->; instance 1
iprb2 -->; instance 2
Using /kernel/drv/iprb.conf file as below for forcing iprb0 interface to 100 Full duplex:
# vi /kernel/drv/iprb.conf
# Driver.conf file for the [NIC card here]
#
# Copyright (c) 1996, by Sun Microsystems, Inc.
# All Rights Reserved.
#
#ident "@(#)iprb.conf 1.5 98/11/06 SMI"
#
name="iprb" parent="pseudo" instance=0 speed=100 full-duplex=1;

Q. How do you set iprb parameter for more than one iprb interface?
Following lines in /kernel/drv/iprb.conf file will force
iprb0 ----->; 100 fdx
iprb1 ----->; 10 hdx
iprb2 ----->; 100 fdx
# vi /kernel/drv/iprb.conf
name="iprb" parent="pseudo" instance=0 speed=100 full-duplex=1;
name="iprb" parent="pseudo" instance=1 speed=10 full-duplex=0;
name="iprb" parent="pseudo" instance=2 speed=100 full-duplex=1;

kinux

原帖由 "南非蜘蛛"] here 发表：

#
# Copyright (c) 1996, by Sun Microsystems, Inc.
# All Rights Reserved.
#
#ident "@(#)iprb.conf 1.5 98/11/06 SMI"
#
name="iprb" parent="pseudo" instance=0 speed=100 full-duplex=1..........

hey guy!!! Where do you get those documents, just give me all in once time...  OK??  Thanks very much...

laoxia

蜘蛛小姐，iprb 是 what 玩艺？

kinux

[quote]原帖由 "laoxia"]蜘蛛小姐，iprb 是 what 玩艺？[/quote 发表：


intel network card, is it??

xmy

好像改system也行。