ScO安装不成功!Why?!

power4_xp

为什么我的SCO装在联想赛扬533上老是no os?

fl.w

SCO OpenServer Handbook
Chapter 10, Starting and stopping the system


System fails to boot or displays ``NO OS'' message
**************************************************

If the system fails to boot or you see the NO OS message, the blocks containing the partition boot
blocks (/etc/hd0boot and /etc/hd1boot) or masterboot block (/etc/masterboot) may have been
corrupted. To restore them:

1. Insert the boot floppy from your emergency boot floppy set and boot from it. When the
   Boot: prompt appears, enter:

   hd(40)unix

2. Enter single user mode and enter these commands at the root prompt:

   instbb hd /dev/hd0a
   dparam -w

   instbb(ADM) writes the partition boot blocks to the hard disk. dparam(ADM) writes the
   masterboot code to the masterboot block on the hard disk.

For some disks it may also be necessary to stamp the disk geometry as described in dparam
(ADM).

fl.w

SCO OpenServer Handbook
Chapter 10, Starting and stopping the system


System fails to boot or displays ``NO OS'' message
**************************************************

If the system fails to boot or you see the NO OS message, the blocks containing the partition boot
blocks (/etc/hd0boot and /etc/hd1boot) or masterboot block (/etc/masterboot) may have been
corrupted. To restore them:

1. Insert the boot floppy from your emergency boot floppy set and boot from it. When the
   Boot: prompt appears, enter:

   hd(40)unix

2. Enter single user mode and enter these commands at the root prompt:

   instbb hd /dev/hd0a
   dparam -w

   instbb(ADM) writes the partition boot blocks to the hard disk. dparam(ADM) writes the
   masterboot code to the masterboot block on the hard disk.

For some disks it may also be necessary to stamp the disk geometry as described in dparam
(ADM).

power4_xp

谢字先行!
   试试去!

sdccf

CMOS中把硬盘的工作模式设置为LBA一般可以解决问题.

power4_xp

LBA试过了,不行.

power4_xp

用软盘引导成功了，提示CONFIG:itimer: not installed
                                  ERROR:cannot open /dev/log
进入系统，
然后用instbb hd /dev/hd0a
         dparam -w
重启后问题依旧。
各位还有什么高招？