- 论坛徽章:
- 0
|
哪位能帮帮我？
After you download from intel website above.
The Intel eeG driver has been tested on SCO OpenServer* version
5.0.6. For UNIX support or for updated drivers, please contact the
operating system vendor.
Instructions for Installing the eeG Driver for SCO OpenServer
===========================================
1. Copy the eeG.vol file to any directory, say /tmp,
on the SCO system, renaming the file as VOL.000.000. Also, make
the file read-only by using 'chmod'.
For example,
# cp eeG.vol /tmp/VOL.000.000
# chmod 444 /tmp/VOL.000.000
2. If there is an older version of the eeG driver on the system, you
must first remove it. To do this, run 'netconfig'. Remove all
instances of the "Intel PRO/1000..." adapters. Exit netconfig
without opting to relink the kernel. Next, run 'custom' and
remove the previous "Intel(R) PRO/1000 Network Drivers" version.
3. Install the new driver using 'custom'. When asked for the
installation media, choose 'media images', and type the directory
path to the VOL.000.000 file. (In step 1, if you copied it to
/tmp, type '/tmp'). After the installation of the driver is
complete, exit 'custom'.
4. Run 'netconfig' and add the adapters. For each adapter that is
present in the system, enter the appropriate TCP/IP parameters.
By default, the driver automatically detects the line speed and
duplex mode. If you want to force any of these settings, choose
'Advanced Options' and set the speed and duplex modes. Exit
'netconfig' and choose to relink the kernel.
5. Reboot the system.
regarding the device & function, it will automatic select for you. if you select yourself. make sure it do not conflict with other hardware.
GOOD LUCK! |
|
免费注册
发表于 2003-05-20 16:14
位有unix5.05下的驱动或者告诉我在哪儿下载，如何安装并且配置？谢谢！我是新手，还望老大多多帮忙！小弟在此多谢了！！！！！
