NETDEV WATCHDOG eth3 transmit timed out
netdev watchdog: eth1: transmit timed out Dec 21 10:12:44 localhost kernel: b44: eth1: transmit timed out, resetting Dec 21 10:12:45 localhost kernel: b44: eth1: Link is down. Dec 21 10:12:47 localhost kernel: b44: eth1: Link is up at 100 Mbps, full duplex. Dec 21 10:12:47 localhost kernel: b44: eth1: Flow control is on for TX and on for RX. Dec 21 10:13:22 localhost kernel: netdev watchdog: eth1:...
我用的是红帽子9.0，双网卡，都为联想D-LINK 530TX， 以前用得好好的，可最近不知为什么，老提示如下错误： Jun 8 11:06:27 yintech kernel: netdev watchdog: eth1: transmit timed out Jun 8 11:06:27 yintech kernel: eth1: transmit timed out, status 0000, PHY statu s 782d, resetting... Jun 8 11:07:55 yintech kernel: netdev watchdog: eth1: transmit timed out Jun 8 11:07:55 yintech kernel: eth1: transmit ti...
怎样改变eth0,eth1,eth2,eth3所对应的物理网卡？ -------------------------------------------------------------------------------- 我有4块网卡， 不管我怎样交换网卡在PCI插槽的顺序， 系统检测出来的eth0,eth1,eth2,eth3的顺序总不是我期望的对应物理网卡的顺序。 请问有什么办法人为指定eth0~3所对应的物理网卡吗？ 多谢！
s@RHEL4 network-scripts]# ifup eth3 3c59x device eth3 does not seem to be present, delaying initialization.
Dec 21 22:12:05 localhost modprobe: modprobe: Can't locate module eth2 Dec 21 22:12:05 localhost modprobe: modprobe: Can't locate module eth3 Dec 21 22:12:05 localhost modprobe: modprobe: Can't locate module eth4 Dec 21 22:12:05 localhost modprobe: modprobe: Can't locate module eth5 Dec 21 22:12:05 localhost modprobe: modprobe: Can't locate module eth6 Dec 21 22:12:05 localhost modprobe: modprobe:...
我用的是RedHat As2.1,想mount其某机器上的文件（其他机器都可以mount过来），但新装的这台不知道是抽什么风，居然只报个错误：mount: RPC: timed out，检查了很多配置，俺没发现错误，不知道各位大虾有何指教？不胜感激，急！急！急！
aix 5300-01 as server from PC to telnet/ssh into the server every 10 minutes if nothing input then the connection was closed. how to change this time from 10minutes into 1hour? thanks. when disconnected get a message like this: Connection to hostxxxx closed by remote host
我在内网上ftp服务器时，出现ftp: connect: Connection timed out，有时又可以ftp上去，但下载文件时只有0点几K，很慢很慢，不知道什么原因？
服务器是 Linux,也是域名服务器. 我用 IPTABLES 写了一个很长的 脚本文件，主要是 限制内网访问一些外部的站点。 可是运行大概10分钟后，域名服务器就不能解析域名了，用IP地址可以访问外网. 用 nslookup 查询,提示:" connection timed out; no servers could be reached " 但是 53端口还在监听 啊。 如果我清除 IPTABLES 规则，马上就可以用域名访问外网了。 哪位 高手 帮我看看是什么原因.
